|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. |
|
|
1 |
Front Bumper Impact Bar Bolt (Qty:?€‰8) Caution: Refer to Fastener Caution.
100?€‰Y (74?€‰lb?€‰ft) |
|
2 |
Front Bumper Impact Bar Procedure
|
Front Bumper Lower Impact Bar Replacement
Rear BumperAirbag Steering Wheel Module Coil Centering
Note: If a double wire harness strap is installed onto the wire
harness assembly and steering column, the original holder for the wire strap(s)
MUST be reused during installation.
Remove the wire harness strap(s) where necessary.
Caution: The new SIR coil assembly will ...
Front Compartment Fuse Block Replacement
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the junction block cover (1).
Remove the positive battery cable nut (1) from the junction block.
Remove the pos ...
Drive Belt Tensioner Replacement
Special Tools
EN-955 Locking Pin
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the right front wheelhouse liner extension. Refer to Front Wheelhouse
Liner Inner Front Extension Replacement
Install the engine su ...