Chevrolet Sonic Repair Manual: Front Floor Console Cover Replacement (Manual Transmission)
- Removal Procedure
-
- Use a flat bladed plastic trim tool in order to release the retainers securing the console cover?€‰(1) to the console assembly.
- Reach under the console cover assembly?€‰(1) and release the retainer tabs securing the transmission shift lever boot?€‰(2) to the console cover assembly.
- Feed the transmission control lever boot assembly thru the opening in the console cover assembly?€‰(1).
- Remove the console cover assembly?€‰(1) from the vehicle.
- Installation Procedure
-
- Position the console cover assembly?€‰(1) to the console assembly.
- Feed the transmission control lever boot assembly thru the opening in the console cover assembly?€‰(1).
- Snap the transmission control lever boot assembly?€‰(2) to the console cover?€‰(1) ensuring the retainer tabs lock the boot assembly to the cover.
- Install the cover assembly to the console.
Front Floor Console Cover Replacement (Automatic Transmission)
Front Floor Console Cover Replacement
Callout
Component Name
1
Front Floor Console Cover Assembly
Procedures
Appl ...
Front Floor Console Cup Holder Replacement
Front Floor Console Cup Holder Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console assembly ...
Other materials:
Hood Adjustment
Hood Adjustment
Callout
Component Name
1
Hood
Caution: Refer to Fastener Caution.
Procedure
Loosen the 4 hood hinge nuts.
Adjust the hood in order to obtain an even gap on both sides between
...
Steel Wheel Repair Description
Caution: Do not heat wheels in an attempt to soften them for straightening
or repair damage from striking curbs, etc. Do not weld wheels. The alloy used
in these wheels is heat-treated and uncontrolled heating from welding affects
the properties of the material.
Caution: The use o ...
Camshaft Timing Chain Installation
Special Tools
EN-952 Fixing Pin
EN-953-A Fixing Tool
EN-955-10 Fixing Pin from EN-955 Kit
For equivalent regional tools, refer to Special Tools.
The engine should be adjusted to TDC.
The crankshaft should be locked with EN-952 fixing pin.
The camshaft should be locked with EN-9 ...
0.0072