Chevrolet Sonic Repair Manual: Front Floor Console Cover Replacement (Manual Transmission)
- Removal Procedure
-
- Use a flat bladed plastic trim tool in order to release the retainers securing the console cover (1) to the console assembly.
- Reach under the console cover assembly (1) and release the retainer tabs securing the transmission shift lever boot (2) to the console cover assembly.
- Feed the transmission control lever boot assembly thru the opening in the console cover assembly (1).
- Remove the console cover assembly (1) from the vehicle.
- Installation Procedure
-
- Position the console cover assembly (1) to the console assembly.
- Feed the transmission control lever boot assembly thru the opening in the console cover assembly (1).
- Snap the transmission control lever boot assembly (2) to the console cover (1) ensuring the retainer tabs lock the boot assembly to the cover.
- Install the cover assembly to the console.
Engine Replacement (Manual Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover .
CH-807 Closure Plugs .
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and ...
Front Wheel Drive Shaft Seal Replacement - Left Side
Special Tools
DT-446 Installer Drift
DT-7004 Slide Hammer
DT-23129 Universal Seal Remover
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and ...
Other materials:
Safety Belts
This section of the manual describes how to use safety belts properly. It also
describes some things not to do with safety belts.
Warning
Do not let anyone ride where a safety belt cannot be worn properly. In a crash,
if you or your passenger(s) are not wearing safety belts, injuries can be mu ...
Rear Side Door Window Replacement (Sedan)
Rear Side Door Window Replacement
Callout
Component Name
Warning: Refer to Glass and Sheet Metal Handling Warning.
Preliminary Procedures
Remove the rear side door trim panel. Refer to Rear Side Door Trim
...
Secondary Air Injection Check Valve Installation
Install a NEW secondary air injection check valve gasket (1).
Install the secondary air injection check valve (2).
Caution: Refer to Fastener Caution.
Install the 3 secondary air injection check valve bolts (3) and tighten
to 22 Y (16& ...
0.0051