Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Lower Grille Replacement

Chevrolet Sonic Repair Manual / Body / Body Exterior / Front Grille / Front Lower Grille Replacement



Front Lower Grille Replacement

Callout

Component Name

Preliminary Procedures

  1. Remove the front bumper fascia assembly. Refer to Front Bumper Fascia Replacement.
  2. Remove the front bumper fascia energy absorber. Refer to Front Bumper Energy Absorber Replacement.

1

Radiator Lower Front Grille

Procedure

  1. Release the four upper tabs from the front bumper fascia.
  2. Release the two outer center tabs from the front bumper fascia.
  3. Release the four lower tabs from the front bumper fascia.
  4. Push the lower grille assembly outward, from the front bumper fascia in order to remove.
  5. Upon installation, index the right center alignment pin to the front bumper fascia first, followed by the ten locking tabs on the lower grille assembly to the front bumper fascia.
  6. Push the locking tabs inward at all ten locations, in order to secure the radiator lower front grille to the front bumper fascia.

2

Front License Plate Bracket Assembly

Procedure

Remove the four screws and the front license plate bracket to transfer to the new lower front grille assembly, (if equipped).

Air Inlet Grille Panel Replacement
Air Inlet Grille Panel Replacement Callout Component Name Preliminary Procedure Remove both wiper arm assemblies. Refer to Windshie ...

Front Upper Grille Replacement
Front Upper Grille Replacement Callout Component Name Preliminary Procedure Remove the front bumper fascia. Refer to Front Bump ...

Other materials:

Engine Compartment Fuse Block
LUV and LUW Engines The engine compartment fuse block is on the driver side of the vehicle, near the battery. Caution Spilling liquid on any electrical component on the vehicle may damage it. Always keep the covers on any electrical component. To access the fuses, press the clips together, ...

Fabric/Carpet/Suede
Start by vacuuming the surface using a soft brush attachment. If a rotating brush attachment is being used during vacuuming, only use it on the floor carpet. Before cleaning, gently remove as much of the soil as possible using one of the following techniques: Gently blot liquids with a pap ...

Battery Positive and Negative Cable Replacement
Removal Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the fuse block and battery positive cable cover. Remove the battery tray. Refer to Battery Tray Replacement. Remove the battery posit ...

В© 2014-2025 Copyright www.csmans.com
 
0.008