|
Callout |
Component Name |
|---|---|
|
1 |
Driver or Passenger Seat Belt Tensioner Cover Procedure
Remove the tensioner cover by pushing downward on the rear and center of the cover. Then applying light pressure to the front of the cover, push the cover rearward to remove it from the seat frame. |
SIR Seatbelt Pretensioner Handling Warning
Front Seat Belt Anchor Plate Tensioner ReplacementBody Waterleak Repair
Warning: If the vehicle interior is exposed to moisture and becomes
soaked up to the level of the sensing and diagnostic module (SDM), the SDM and
SDM harness connector must be replaced. The SDM could be activated when powered,
which could cause airbag deployment and result in person ...
Environmental Fallout (Acid Rain)
Caution: Refer to Clearcoat/Ultraviolet Screeners Caution.
Note: Always refer to the manufacturer's packaged instructions for
the detailed procedures of materials used for compounding and/or polishing.
Since the severity of the condition varies from area to area, proper diagno ...
Camshaft Cover Installation
Clean the sealing surfaces.
Note: The thickness of the sealing bead should be 2 mm (0.0787 in).
Apply sealing compound to areas (1) and (2). Refer to Adhesives, Fluids,
Lubricants, and Sealers.
Note: The installation procedure sho ...