Chevrolet Sonic Repair Manual: Front Seat Cushion Outer Trim Panel Replacement

Chevrolet Sonic Repair Manual / Body / Body Interior / Trim Panels/Welts / Front Seat Cushion Outer Trim Panel Replacement

Front Seat Cushion Outer Trim Panel Replacement
Callout	Component Name
Preliminary Procedures Remove the driver or passenger seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement Remove the front seat adjuster handle. Refer to Driver or Passenger Seat Adjuster Handle Replacement
1	Front Seat Cushion Outer Trim Panel Fasteners (Qty:?€‰3) Caution: Refer to Fastener Caution.
2	Front Seat Cushion Outer Trim Panel Procedure Make sure the seat is in the full up position. Gently pull outboard on the front half of the finish cover to disengage the panel rib from the seat frame. Firmly grasp the upper area of the finish cover that folds over the seat cushion frame, this area needs to be flexed outward while sliding the finish cover upward. If replacing the cover, transfer components as necessary.

Front Seat Cushion Inner Trim Panel Replacement

Front Seat Cushion Inner Trim Panel Replacement Callout Component Name 1 Driver or Passenger Seat Inner Recliner Finish ...

Front Side Door Trim Replacement

Front Side Door Trim Replacement Callout Component Name Preliminary Procedure Remove the front side door upper front trim panel ...

Other materials:

Rear Compartment Sill Trim Plate Replacement
Rear Compartment Sill Trim Plate Replacement Callout Component Name Preliminary Procedure Partially remove the rear compartment opening weatherstrip. Refer to Rear Compartment Lid Weatherstrip Replacement. ...

Rear Wheel Bearing and Hub Replacement (Disc Brake)
Special Tools EN–45059 Angle Meter For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Insta ...

Drive Belt Installation
Special Tools EN-955 Locking Pins EN-48488 Holding Wrench For equivalent regional tools, refer to Special Tools. Note: Ensure that the drive belt tensioner is held with EN-955?E locking pin. Install the drive belt. Move the drive belt tensioner clockwise until EN- ...

0.007