Chevrolet Sonic Repair Manual: Front Seat Outboard Seat Back Airbag Replacement

Chevrolet Sonic Repair Manual / Body / Restraints / Air Bag Modules / Front Seat Outboard Seat Back Airbag Replacement

Front Seat Outboard Seat Back Airbag Replacement
Callout	Component Name
Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: The seat cushion frame The seat recliner, if equipped The seat adjuster The seat back frame Failure to do so may cause future personal injury. Warning: Do not repair or replace the seat stitching or seams in the seat back trim cover with an internal mounted seat side airbag module. Replace the complete seat back trim cover from the OEM. Non-OEM seat stitching may cause improper airbag deployment which could result in personal injury. Preliminary Procedure Disable the SIR system. Refer to SIR Disabling and Enabling. Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation. Remove the driver or passenger seat back cushion cover and pad. Refer to Driver or Passenger Seat Back Cover and Pad Replacement.
1	Seat Side Inflatable Restraint Module Nut (Qty:?€‰2) Caution: Refer to Fastener Caution Tighten 4?€‰Y (35?€‰lb?€‰in)
2	Driver or Passenger Seat Side Inflatable Restraint Module Procedure Disconnect the electrical connector. Remove the seat side inflatable restraint module. Refer to Inflatable Restraint Module Handling and Scrapping.

Airbag Steering Wheel Module Replacement

Removal Procedure Warning: Refer to SIR Inflator Module Handling and Storage Warning. Warning: Refer to SIR Warning. Disable the SIR system. Refer t ...

Instrument Panel Airbag Arming Status Display Replacement

Instrument Panel Airbag Arming Status Display Replacement Callout Component Name Preliminary Procedure Remove the heater and ai ...

Other materials:

Radio Controls with Touchscreen
Audio Source Menu VOL (Volume): Press to increase or decrease the volume. (Power): Press and hold to turn the system on and off. (Home Page): Press to enter the Home Page. ...

Cylinder Head Installation
Special Tools EN-45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Clean the sealing surfaces. Inspect for plane surface. Cylinder block, cylinder head Straight-edge, feeler gauge Install the cylinder head gasket. Install the cylinder head. ...

Evaporative Emission Canister Replacement (Steel Tank)
Removal Procedure Remove the evaporative emission canister bracket fasteners (1). Disconnect the purge solenoid valve electrical connector (1). Disconnect the evaporative emission canister vent hose (2). Disconnect the evaporative emission c ...

0.0048