|
Callout |
Component Name |
|---|---|
|
1 |
Front Seat Riser Finish Cover Caution: Do not twist the cover during removal. Twisting the cover may cause the component to break. Procedure
Remove the finish cover by firmly grasping the front or rear of the cover and pulling the cover outward then upward to disengage it from the track. |
Front Seat Back Recliner Handle ReplacementStarting Procedure
1. With your foot off the accelerator pedal, turn the ignition to START. When
the engine cranks, let go of the key. The idle speed will go down as the engine
gets warm.
The vehicle has a Computer-Controlled Cranking System. It assists in starting
the engine and protects components. If the ign ...
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Fluid Pump Selective Measurement
Fluid Pump Selective Measurement
Callout
Component Name
1
A/Trans Fluid Pump Body
Note: Measure the distance from the bottom of a gauge bar
to the bottom of the pump rotor cavity. Refer to
Fluid Pump Sel ...