Rear Seats
Seat AdjustmentCenter Pillar Reinforcement Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note: The center pillar upper stiffener is made of Dual Phase
Steel and should be replaced only at ...
Instrument Panel Center Molding Replacement (Without U58)
Instrument Panel Center Molding Replacement
Callout
Component Name
1
Instrument Panel Center Molding Assembly
Procedure
Use a flat bladed plastic trim tool in the shown locations, then
rotate the trim tool 90 ...
Throttle Body Inspection and Cleaning
Note: Over extended time and mileage, deposits may accumulate on the
back of the throttle valve plate. The source of the deposit is exhaust gas.
Typically these deposits pose no problem. Occasionally the deposit may accumulate
to a point where perceived pedal effort or throttle valve mov ...