Chevrolet Sonic Repair Manual: Front Side Door Lock Cylinder Rod Replacement

Chevrolet Sonic Repair Manual / Accessories / Security & Keyless Entry / Locks / Front Side Door Lock Cylinder Rod Replacement

Front Side Door Lock Cylinder Rod Replacement
Callout	Component Name
Preliminary Procedure Remove the rear side door window rear guide. Refer to Rear Side Door Window Rear Guide Replacement. Remove the rear side door lock. Refer to Rear Side Door Latch Replacement.
1	Rear Side Door Lock Cylinder Rod Procedure Place the window in the full up position. Remove the water deflector. In order to prevent outside handle lever pre-load, lock, outside handle, handle bracket and cover/cap shall be fully secured to the door prior to securing integral lock clip to outside handle rod. Integral lock clip shall be in the full up position while securing to outside handle rod. Refer to Front Side Door Outside Handle Rod Adjustment. Tip: Inspect the door lock system for proper operation before installing the door trim panel.

Front Side Door Lock Cylinder Replacement

Front Side Door Lock Cylinder Replacement Callout Component Name 1 Front Side Door Lock Cylinder Screw Access Plug ...

Lock Cylinder Coding - Ignition

The ignition lock cylinder uses 8 key cut positions, 1–8. The ignition cylinder tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in and ar ...

Other materials:

Dome Lamp Bulb Replacement
Dome Lamp Bulb Replacement Callout Component Name Preliminary Procedure Remove the windshield header courtesy lamp. Refer to Windshield Header Courtesy Lamp Replacement 1 Dome Lamp Bulb ...

Brake Rotor/Drum Balance Inspection
Support the vehicle drive axle on a suitable hoist. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assemblies from the drive axle. Refer to Tire and Wheel Removal and Installation. Warning: Refer to Work Stall Test Warning. Reinstall the wheel nuts in ...

Transmission Case Disassemble (Gen 1)
Special Tools 3-9506289 Universal Adapter J-810700 Mainshaft Bearing Remover J-810704 Center Bar Puller M-680770 Universal Sliding Mallet R-0007758 Holding Fixture R-0007770 Holding Fixture Adapter Plates T-0307000 Extractor and Driver Fixture T-9807671 Slide Hammer For eq ...

0.0058