Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Side Door Lock Cylinder Rod Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Front Side Door Lock Cylinder Rod Replacement



Front Side Door Lock Cylinder Rod Replacement

Callout

Component Name

Preliminary Procedure

  1. Remove the rear side door window rear guide. Refer to Rear Side Door Window Rear Guide Replacement.
  2. Remove the rear side door lock. Refer to Rear Side Door Latch Replacement.

1

Rear Side Door Lock Cylinder Rod

Procedure

  1. Place the window in the full up position.
  2. Remove the water deflector.
  3. In order to prevent outside handle lever pre-load, lock, outside handle, handle bracket and cover/cap shall be fully secured to the door prior to securing integral lock clip to outside handle rod. Integral lock clip shall be in the full up position while securing to outside handle rod. Refer to Front Side Door Outside Handle Rod Adjustment.

Tip:

Inspect the door lock system for proper operation before installing the door trim panel.

Front Side Door Lock Cylinder Replacement
Front Side Door Lock Cylinder Replacement Callout Component Name 1 Front Side Door Lock Cylinder Screw Access Plug ...

Front Side Door Opening Floor Carpet Retainer Replacement
Front Side Door Opening Floor Carpet Retainer Replacement Callout Component Name 1 Front Side Door Opening Floor Carpet ...

Other materials:

Automatic Transmission
P (Park): This position locks the front wheels. It is the best position to use when you start the engine because the vehicle cannot move easily. Warning It is dangerous to get out of the vehicle if the shift lever is not fully in P (Park) with the parking brake firmly set. The vehicle can ro ...

Instrument Panel Knee Bolster Replacement
Instrument Panel Knee Bolster Replacement Callout Component Name Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling. Remove the driver inflatable restraint instrument panel lower module. ...

Reverse (Gen 2)
When the gear selector lever is moved to the Reverse (R) position (from the Park position) the normally-low 35R pressure control solenoid is commanded ON and the following changes occur in the transmission? hydraulic and electrical systems: 3-5-Reverse Clutch Applies Manual Valve ...

В© 2014-2026 Copyright www.csmans.com
 
0.0058