Chevrolet Sonic Repair Manual: Front Side Door Trim Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Front Side Door Trim Replacement

Front Side Door Trim Replacement
Callout	Component Name
Preliminary Procedure Remove the front side door upper front trim panel. Refer to Front Side Door Upper Front Trim Panel Replacement.
1	Front Side Door Inside Handle Bolt Finish Cap
2	Front Side Door Inside Handle Fastener Caution: Refer to Fastener Caution.
3	Front Side Door Trim Fastener Procedure Use a small flat-bladed tool to open the front side door trim integral cap to access the fastener.
4	Front Side Door Trim Assembly Procedure Use the appropriate plastic trim tool to aid in the removal of the door trim. Pull upwards on the door lock retainer cable to disengage. Disconnect the electrical connector.

Front Side Door Replacement

Front Side Door Replacement Callout Component Name Warning: Refer to SIR Warning. Preliminary Procedures Mark the ...

Front Side Door Upper Front Trim Panel Replacement

Front Side Door Upper Front Trim Panel Replacement Callout Component Name 1 Front Side Door Upper Front Trim Panel Assem ...

Other materials:

Repairing Damaged Wire Insulation
If the wire insulation has been chafed, or broken, enough to show the conductive portion of the wire, and the wire is not damaged, determine the length of insulation that needs to be repaired. If the repair is less than 280?€‰mm (11?€‰in), cut the wire within the damaged area. Then sli ...

Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange, remeasure the tire and wheel assembly on-vehicle runout in order to verify that the amount of runout has been reduced and brought to within tolerances. Mark the location of the high spot on the tire and wheel asse ...

Piston and Connecting Rod Assemble
Special Tools EN-49941 Remover / Installer Piston Retainer Ring For equivalent regional tools, refer to Special Tools. Note: Lubricate the piston pin with clean engine oil. Install the connecting rod (3) and the piston pin (2) to the piston (1). Install t ...

0.0061