Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Left Side

Chevrolet Sonic Repair Manual / Chassis / Wheels/Tires / Wheels / Front Wheel Drive Shaft Seal Replacement - Left Side



Front Wheel Drive Shaft Seal Replacement - Left Side

Callout

Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the left wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement.

1

Left Front Wheel Drive Shaft Oil Seal

Procedure

  1. For seal removal use GE-6125-1B slide hammer with DT-23129 universal seal remover .
  2. For seal installation use GE-8092 driver handle with DT-47790 seal installer .
Special Tools

  • DT-23129 Universal Seal Remover
  • DT-47790 Seal Installer
  • GE-6125–1B Slide Hammer
  • GE-8092 Driver Handle

For equivalent regional tools, refer to Special Tools.

Front Wheel Drive Shaft Seal Replacement - Case Side
Front Wheel Drive Shaft Seal Replacement - Case Side Callout Component Name 1 Front Wheel Drive Shaft Oil Seal Specia ...

Front Wheel Drive Shaft Seal Replacement - Right Side
Front Wheel Drive Shaft Seal Replacement - Right Side Callout Component Name Preliminary Procedures Raise and support the vehicle. ...

Other materials:

Sunroof Housing Front Drain Hose Replacement
Sunroof Housing Front Drain Hose Replacement Callout Component Name Preliminary Procedure It is only necessary to lower the headliner. Only do those steps in the headliner replacement procedure that will lower the headliner ...

Replacement Wheels Description
Replace the wheel if any of the following conditions exist: The wheel exhibits excessive runout. The wheel is bent. The wheel is cracked. The wheel is severely rusted. The wheel is severely corroded. Note: Air leaks caused by porosity on aluminum wheels are repairable. ...

Warm Up Three-Way Catalytic Converter Removal
Disconnect the heated oxygen sensor wiring harness (3) from retainer clip. Remove the 2 catalytic converter to catalytic converter bracket nuts (4) and (6). Loosen the three way warm up catalytic converter V-clamp (1). Remove the three way warm up ...

© 2014-2026 Copyright www.csmans.com
 
0.0132