Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Right Side

Chevrolet Sonic Repair Manual / Powertrain / Driveline / Driveshafts / Front Wheel Drive Shaft Seal Replacement - Right Side

Front Wheel Drive Shaft Seal Replacement - Right Side
Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front wheel drive shaft from the transmission. Refer to Front Wheel Drive Shaft Replacement.
1	Right Front Wheel Drive Shaft Oil Seal Procedure Remove the right front wheel drive shaft oil seal using the DT-7004 hammer and the DT-23129 universal seal remover. Coat the NEW right front wheel drive shaft oil seal with transmission fluid. Install the NEW right front wheel drive shaft oil seal using the DT-519 drift and hammer. Note: Do not reuse the wheel drive shaft oil seal. Special Tools DT-519 Installer Drift DT-7004 Slide Hammer DT-23129 Universal Seal Remover For equivalent regional tools, refer to Special Tools.

Front Wheel Drive Shaft Seal Replacement - Left Side

Front Wheel Drive Shaft Seal Replacement - Left Side Callout Component Name Preliminary Procedure Raise and support the vehicle. Re ...

Front Wheel Drive Shaft Seal Replacement - Right Side

Special Tools DT-446 Installer Drift DT-7004 Slide Hammer DT-23129 Universal Seal Remover For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and ...

Other materials:

Rear Seat Back Cushion Cover and Pad Replacement (AMA 60% w/Split Back)
Rear Seat Back Cushion Cover and Pad Replacement Callout Component Name Preliminary Procedure Remove the rear seat back cushion. Refer to Rear Seat Back Cushion Removal and Installation Remove the rear seat head restraint ...

Front Disc Brake Pads Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Note: Always replace disc brake pads in axle sets. Inspect the fluid level in the brake master cylinder reservoir. If the brake fluid level is midway between the maximum-full point and the minimum allowab ...

Intake Manifold Installation (1.6L LDE)
Clean the sealing surfaces. Insert the NEW gasket. Caution: Refer to Fastener Caution. Install the intake manifold (2) and the 7 intake manifold bolts (1) and tighten to 20 Y (15 lb ft). Install the intake manifold supp ...

0.0059