Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Right Side

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Front Wheel Drive Shaft Seal Replacement - Right Side



Front Wheel Drive Shaft Seal Replacement - Right Side

Callout

Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement.

1

Right Front Wheel Drive Shaft Oil Seal

Procedure

  1. For seal removal use GE-6125-1B slide hammer with DT-23129 universal seal remover .
  2. For seal installation use GE-8092 driver handle with DT-47790 seal installer .
Special Tools

  • DT-23129 Universal Seal Remover
  • DT-47790 Seal Installer
  • GE-6125-1B Slide Hammer
  • GE-8092 Driver Handle

For equivalent regional tools, refer to Special Tools.

Transmission Mount Replacement - Left Side
Removal Procedure Remove the battery tray. Refer to Battery Tray Replacement. Install the engine support fixture. Refer to Engine Support Fixture. Remove and DIS ...

Input Shaft Support Replacement (Gen 1)
Input Shaft Support Replacement Callout Component Name 1 3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 4) ...

Other materials:

New Vehicle Break-In
Caution The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: . Do not drive at any one constant speed, fast or slow, for the first 805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake or slo ...

Instrument Panel, Leather, Vinyl, Other Plastic Surfaces, Low Gloss Paint Surfaces and Natural Open Pore Wood Surfaces
Use a soft microfiber cloth dampened with water to remove dust and loose dirt. For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap solution. Caution Soaking or saturating leather, especially perforated leather, as well as other interior surfaces, may cause per ...

Brake Pedal Position Sensor Replacement
Removal Procedure Remove the instrument panel lower trim pad cover. Refer to Instrument Panel Lower Trim Pad Cover Replacement. Disconnect the brake pedal position sensor electrical connector. Remove the brake pedal position sensor bolt?€‰(1). Remove t ...

© 2014-2025 Copyright www.csmans.com
 
0.0062