Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Right Side

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Manual / General / Front Wheel Drive Shaft Seal Replacement - Right Side

Front Wheel Drive Shaft Seal Replacement - Right Side
Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front wheel drive shaft from the transmission. Refer to Front Wheel Drive Shaft Replacement.
1	Right Front Wheel Drive Shaft Oil Seal Procedure Remove the right front wheel drive shaft oil seal using the DT-7004 hammer and the DT-23129 universal seal remover. Coat the NEW right front wheel drive shaft oil seal with transmission fluid. Install the NEW right front wheel drive shaft oil seal using the DT-519 drift and hammer. Note: Do not reuse the wheel drive shaft oil seal. Special Tools DT-519 Installer Drift DT-7004 Slide Hammer DT-23129 Universal Seal Remover For equivalent regional tools, refer to Special Tools.

Front Wheel Drive Shaft Seal Replacement - Left Side

Special Tools DT-446 Installer Drift DT-7004 Slide Hammer DT-23129 Universal Seal Remover For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and ...

Gear Position Sensor Replacement

Gear Position Sensor Replacement Callout Component Name Preliminary Procedure Unclip the engine control module (ECM) and bracke ...

Other materials:

Dinghy Towing RS Model with Automatic Transmission
Caution If the vehicle is towed with all four wheels on the ground, the drivetrain components could be damaged. The repairs would not be covered by the vehicle warranty. Do not tow the vehicle with all four wheels on the ground. The vehicle was not designed to be towed with all four wheels o ...

Brake Rotor Thickness Variation Measurement
Warning: Refer to Brake Dust Warning. Note: Any disc brake rotor that exhibits thickness variation exceeding the maximum acceptable level must be refinished or replaced. Thickness variation exceeding the maximum acceptable level can cause brake pulsation. If the inboard fricti ...

Intake Camshaft Replacement
Removal Procedure Remove the camshaft intake and exhaust sprocket. Refer to Camshaft Intake and Exhaust Sprocket Replacement. Remove the camshaft bearing cap bolts in sequence shown. Ensure to remove the bolts one turn at a time until there is no spring tension p ...

0.0048