Chevrolet Sonic Repair Manual: Front Wheel Speed Sensor Replacement
- Removal Procedure
-
Warning:
Refer to Brake Dust Warning.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.
- Disconnect the wheel speed sensor electrical connector (1) and release the connector from the vehicle body.
- Release the wheel speed sensor harness grommets (1) from the brake hose brackets.
- Remove the wheel speed sensor bolt (1).
- Carefully remove the wheel speed sensor (1) from the steering knuckle by pulling the sensor straight upward using a slight twisting motion.
- Installation Procedure
-
- Install the wheel speed sensor (1) to the steering knuckle.
- Install the wheel speed sensor bolt (1) and tighten to 8 Y (71 lb in)
.
- Install the wheel speed sensor harness grommets (1) to the brake hose brackets.
- Connect the wheel speed sensor electrical connector (1) and install the connector to the vehicle body.
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Perform the Diagnostic System Check - Vehicle.
Caution:
Refer to Fastener Caution.
Electronic Brake Control Module Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Remove the batt ...
Rear Wheel Speed Sensor Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer ...
Other materials:
Accessory Power Receptacle Replacement
Special Tools
EL-42059 Cigar Lighter Socket Remover .
For equivalent regional tools. Refer to Special Tools
Removal Procedure
Remove the auxiliary power outlet fuse from the fuse block.
Remove the receptacle:
Look into the receptacle. There are two 3?€‰mm ( ...
Window Motor Programming - Express Function
Window Motor Normalized Procedure
A window motor that has not been normalized will no longer perform the express
up and express down functions, this may occur during the following conditions:
When a window motor has been disconnected
When a door harness has been disconnected
...
Instrument Panel Assembly Replacement
Instrument Panel Assembly Replacement
Callout
Component Name
Preliminary Procedure
Remove the right and left windshield side garnish moldings. Refer
to Windshield Side Garnish Molding Replacement.
Remove the front floor c ...
0.009