Chevrolet Sonic Repair Manual: Fuel Pressure Relief

Chevrolet Sonic Repair Manual / Powertrain / Internal Combustion Powertrain Control / Engine Control / General / Fuel Pressure Relief

Special Tools

EN-34730-91 Pressure Tester

For equivalent regional tools, refer to Special Tools.

Warning:

Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.

Warning:

Relieve the fuel system pressure before servicing fuel system components in order to reduce the risk of fire and personal injury.

After relieving the system pressure, a small amount of fuel may be released when servicing the fuel lines or connections. In order to reduce the chance of personal injury, cover the regulator and the fuel line fittings with a shop towel before disconnecting. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

Remove the fuel injector rail cap (1).

Relieve the fuel pressure. Use EN-34730-91 pressure tester (1).

Fuel Pressure Measurement

Special Tools EN 34730?E1 Pressure Tester For equivalent regional tools, refer to Special Tools Warning: Gasoline or gasoline vapors are highly flammable. A fire could occ ...

Fuel Pump Flow Control Module Replacement

Fuel Pump Flow Control Module Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refe ...

Other materials:

Windshield Washer Solvent Container Hose Replacement
Windshield Washer Solvent Container Hose Replacement Callout Component Name Preliminary Procedure Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. 1 Windshiel ...

Wheel Drive Shaft Outer Joint Inspection
Disassembly Procedure Remove the outer constant velocity (CV) joint and boot from the wheel drive shaft. Refer to Front Wheel Drive Shaft Outer Joint and Boot Replacement. Remove any lubricant from the CV joint. Note: Position the cage and the inner race so they a ...

Input Shaft Assemble
Special Tools J-840733 Driver For equivalent regional tools, refer to Special Tools. Note: Ensure the input shaft rear bearing retaining ring (2) is placed on the input shaft before installing the input shaft rear bearing assembly (1). Place the input sh ...

0.0064