Chevrolet Sonic Repair Manual: Fuel Pump Control Module Programming and Setup
The fuel pump control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the fuel pump control module will not control all of the vehicle features properly.
Ensure that the following conditions exist in order to prepare for fuel pump control module programming:
- The battery is fully charged.
- The MDI data link connectors are secure.
- The scan tool is loaded with the most current software version.
- All disconnected modules and devices are reconnected securely.
- This entire procedure has been reviewed before proceeding.
Do not reprogram the fuel pump control module unless directed by a service procedure or a service bulletin.
- Fuel Pump Control Module Programming
-
To program and setup an existing or new replacement fuel pump control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select FPCM Fuel Pump Flow Control Module - Programming and follow the on-screen instructions.
If the fuel pump control module fails to accept the program, verify all scan tool and fuel pump control module connections are secure.
Note:
After programming is completed, perform the following to avoid future misdiagnosis:
- Turn the Vehicle OFF for 10 seconds.
- Open and close the door.
- Connect the scan tool to the data link connector.
- Vehicle in Service Mode, engine OFF.
- Clear all DTC? from all modules.
Fuel Control
...
Other materials:
Underbody Rear Side Rail Extension Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer ...
Steering Linkage Outer Tie Rod Inspection
Special Tools
GE-8001 Dial Indicator Set
For equivalent regional tools, refer to Special Tools.
Note: This inspection procedure does not supersede local government
required inspections that have more stringent requirements.
Inspect the outer tie rod seal. If the outer tie rod ...
Odor Correction
Eliminating Air Conditioning Odor
Odors may be emitted from the air conditioning system primarily at start
up in hot, humid climates. The following conditions may cause the odor:
Debris is present in the HVAC module.
Microbial growth on the evaporator core
When the blower ...
0.0058