Chevrolet Sonic Repair Manual: Fuel Tank Draining
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the fuel tank filler cap.
- Insert a suitable suction hose into the fuel tank filler pipe.
- Attach a suitable suction hose to the hose used with the hand or air operated pump devise.
- Using a hand or air operated pump drain as much fuel from the tank as possible.
Warning:
Refer to Gasoline/Gasoline Vapors Warning.
Note:
The fuel tank must be drained with a suitable, commercially-available fuel removal unit and suction hose - follow safety regulations and national legislation. The fuel tank is fitted with a refill limit float valve. This is located on the filler neck in the fuel tank. To prevent damaging the refill limit float valve, a suitable suction hose must be used. In the presence of fuel vapors or escaping fuel - observe safety regulations and national legislation. Store drained fuel in a suitable, sealable container.
Fuel System Description
Fuel System Overview
The fuel system is an electronic returnless on-demand design. A returnless
fuel system reduces the internal temperature of the fuel tank by not returning
hot fuel f ...
Fuel Tank Filler Pipe Replacement
Removal Procedure
Remove the bracket fastener (1).
Lift and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the fuel tank filler pip ...
Other materials:
Park - Engine Running (Gen 2)
When the gear selector lever is in the Park (P) position, fluid is drawn into
the pump through the transmission fluid filter assembly. Line pressure is then directed
to the following valves:
Fluid Pressure Directed in Preparation for a Shift
Manual Valve
Mechanically controlled by ...
Warm Up Three-Way Catalytic Converter Installation
Install the warm up three way catalytic converter (5) to the brackets and
the turbocharger. Use a NEW warm up three way catalytic converter seal (2).
Note: Never re-use the V-clamp.
Install a NEW warm up three way catalytic converter V-clamp (1).
In ...
Engine Oil Cooler Disassemble
Remove the oil cooler coolant inlet hose clamp (2).
Remove the oil cooler coolant inlet hose (1).
Remove the oil cooler coolant inlet pipe bolt (7)
Remove the oil cooler coolant inlet pipe (3) and the seal ring (6).
Remove the oil cooler coolant out ...
0.0053