Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Fuel Tank Filler Pipe Replacement (Steel Tank)

Removal Procedure

    Remove the fuel filler door housing. Refer to
  1. Remove the fuel filler door housing. Refer to Fuel Tank Filler Door Latch Housing Replacement.
  2. Remove the bracket fastener (1).

  3. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  4. Remove the fuel tank filler pipe bracket fastener (1).
  5. Remove the vent hose clamp (2) and vent hose.
  6. Loosen the filler pipe hose clamp (3).

  7. Remove the fuel tank filler pipe (1).
Installation Procedure

    Install the fuel tank filler pipe (1).
  1. Install the fuel tank filler pipe (1).

  2. Caution:

    Refer to Fastener Caution.

  3. Tighten hose clamp (3) to 4 Y(35 lb in)

    .

  4. Install the vent hose clamp (2) and vent hose.
  5. Tighten the filler pipe bracket fastener (1) to 9 Y(89 lb in)

    .



  6. Install the bracket fastener (1) and tighten to 9 Y(89 lb in)

    .

  7. Install the fuel filler door housing. Refer to Fuel Tank Filler Door Latch Housing Replacement.
Fuel Tank Filler Pipe Replacement
Removal Procedure Remove the bracket fastener (1). Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the fuel tank filler pip ...

Fuel Tank Fuel Pump Module Replacement
Special Tools EN-48279 Fuel Sender Lock Ring Tool For equivalent regional tools, refer Special Tools. Removal Procedure Relieve the fuel system pressure. Refer to Fuel P ...

Other materials:

Cargo Tie Down Loop Replacement
Cargo Tie Down Loop Replacement Callout Component Name 1 Cargo Tie Down Hook Fastener Caution: Refer to Fastener Caution. Tighten 9?€‰Y (80?€‰lb?€‰in) 2 Cargo T ...

Engine Front Cover and Oil Pump Assemble
Oil Pump Installation Note: The oil pump slide spring and pin, as well as the slide seal and slide seal spring can be ordered as single parts. All other oil pump components can only be ordered as a replacement kit. Install the oil pump components in the fo ...

Reverse (Gen 2)
When the gear selector lever is moved to the Reverse (R) position (from the Park position) the normally-low 35R pressure control solenoid is commanded ON and the following changes occur in the transmission? hydraulic and electrical systems: 3-5-Reverse Clutch Applies Manual Valve ...

© 2014-2022 Copyright www.csmans.com
 
0.0063