Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Fuel Tank Fuel Pump Module Replacement (Steel Tank)

Chevrolet Sonic Repair Manual / Powertrain / Engine / Fuel System / Fuel Tank Fuel Pump Module Replacement (Steel Tank)

Special Tools

EN-48279 Fuel Sender Lock Ring Wrench

For equivalent regional tools, refer to Special Tools.

Removal Procedure
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief.
  2. Remove the fuel tank. Refer to Fuel Tank Replacement.


  3. Disconnect the electrical connectors (1).
  4. Disconnect the evaporative emission and fuel lines (2). Refer to Plastic Collar Quick Connect Fitting Service.


  5. Using the EN-48279 fuel sender lock ring wrench , remove the lock ring (1) by turning counter-clockwise.


  6. Remove the fuel pump module (1) and O-ring (2). Discard the seal.
Installation Procedure

    Install a NEW O-ring (2) and the fuel pump module (1).
  1. Install a NEW O-ring (2) and the fuel pump module (1).

  2. Using the EN 48279 wrench, install the lock ring (1) by turning clockwise.

  3. Connect the electrical connectors (1).
  4. Connect the evaporative emission and fuel lines (2). Refer to Plastic Collar Quick Connect Fitting Service.
  5. Install the fuel tank. Refer to Fuel Tank Replacement.
Fuel Tank Fuel Pump Module Replacement
Special Tools EN-48279 Fuel Sender Lock Ring Tool For equivalent regional tools, refer Special Tools. Removal Procedure Relieve the fuel system pressure. Refer to Fuel Press ...

Fuel Tank Heat Shield Replacement
Removal Procedure Support the fuel tank with a suitable jack. Remove the fuel tank strap fasteners (1) and lower the fuel tank straps (2). Remove the ...

Other materials:

Front Seat Cushion Outer Trim Panel Replacement
Front Seat Cushion Outer Trim Panel Replacement Callout Component Name Preliminary Procedures Remove the driver or passenger seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement Remove the front seat ...

Drive Range, Second Gear (Gen 2)
As vehicle speed increases and operating conditions become appropriate, the transmission control module (TCM) processes input signals from the automatic transmission input and output speed sensors, the throttle position sensor and other vehicle sensors to determine the precise moment to comman ...

Transmission Rear Mount Bracket Replacement
Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement. Using a suitable jack stand, support the rear of the ...

В© 2014-2025 Copyright www.csmans.com
 
0.0078