Chevrolet Sonic Repair Manual: Gear Position Sensor Replacement

Chevrolet Sonic Repair Manual / Powertrain / Internal Combustion Powertrain Control / Transmission Control / Gear Position Sensor Replacement

Gear Position Sensor Replacement
Callout	Component Name
Preliminary Procedure Unclip the engine control module (ECM) and bracket from the battery tray.
1	Gear Position Sensor Magnet Bolt Caution: Refer to Fastener Caution. Tighten 8 Y (71 lb ft)
2	Gear Position Sensor Magnet
3	Gear Position Sensor Bolt Tighten 8 Y (71 lb ft)
4	Gear Position Sensor Procedure Disconnect electrical connector After installation is complete, learn neutral gear sensor. Refer to Control Module References.

Automatic Transmission Shift Lock Control Function Check

Warning: When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. Before starting this check, be sure there is enough roo ...

Transmission/Transaxle

...

Other materials:

Seat Belt Latch Stop Installation
Seat Belt Latch Stop Installation Callout Component Name Preliminary Procedure Locate the hole in the seat belt webbing where the original seat belt stop button was located. If the original hole in the seat belt webbing i ...

Park - Engine Running (Gen 2)
When the gear selector lever is in the Park (P) position, fluid is drawn into the pump through the transmission fluid filter assembly. Line pressure is then directed to the following valves: Fluid Pressure Directed in Preparation for a Shift Manual Valve Mechanically controlled by ...

Engine Front Cover Gasket Installation
Clean the sealing surfaces and remove all remains of old sealing compound material. Note: The thickness of the sealing bead should be 2 mm (0.0787 in). Apply sealing compound to the shown areas (1) and (2). Refer to Adhesives, Fluids ...

0.0082