Chevrolet Sonic Repair Manual: General Description
The factory installed tires are designed to operate satisfactorily with loads up to and including the full rated load capacity when these tires are inflated to the recommended pressures.
The following factors have an important influence on tire life:
- Correct tire pressures
- Correct wheel alignment
- Proper driving techniques
- Tire rotation
The following factors increase tire wear:
- Heavy cornering
- Excessively rapid acceleration
- Heavy braking
Aluminum Wheel Refinishing
Finish Damage Evaluation Procedure
Note:
If the wheels are chrome-plated, do not re-plate or refinish
the wheels.
If the wheels are polished aluminum, do not r ...
Metric Wheel Nuts and Bolts Description
Metric wheel/nuts and bolts are identified in the following way:
The wheel/nut has the word Metric stamped on the face.
The letter M is stamped on the end of the wheel bolt.
The thread sizes ...
Other materials:
Tire Sealant and Compressor Kit
Warning
Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine
exhaust may enter the vehicle. Engine exhaust contains carbon monoxide (CO) which
cannot be seen or smelled. It can cause unconsciousness and even death. Never run
the engine in an enclosed area that has n ...
Neutral - Engine Running (Gen 1)
When the gear selector is moved to the Neutral (N) position, the hydraulic and
electrical system operation is identical to Park (P) range. However, if Neutral
is selected after the vehicle was operating in Reverse (R), the normally-high 35R
pressure control solenoid 2 is commanded OFF and the ...
Drive Range, Fifth Gear (Gen 2)
As vehicle speed increases, the transmission control module (TCM) processes input
signals from the automatic transmission input and output speed sensors, the throttle
position sensor and other vehicle sensors to determine the precise moment to command
ON the normally-low 35R pressure control s ...
0.0086