The factory installed tires are designed to operate satisfactorily with loads up to and including the full rated load capacity when these tires are inflated to the recommended pressures.
The following factors have an important influence on tire life:
The following factors increase tire wear:
Front Wheel Drive Shaft Seal Replacement - Torque Converter Housing Side
Hub/Axle Flange and Wheel Stud Runout InspectionTire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange,
remeasure the tire and wheel assembly on-vehicle runout in order to verify that
the amount of runout has been reduced and brought to within tolerances.
Mark the location of the high spot on the tire and wheel asse ...
Engine Coolant Thermostat Installation
Caution: Refer to Engine Coolant Thermostat Housing Caution.
Clean the engine coolant sealing surfaces.
Install the engine coolant seal (1).
Install the engine coolant thermostat assembly (2).
Caution: Refer to Fastener Caution.
Install the 4R ...
Transmission Control Replacement
Removal Procedure
Remove the floor console. Refer to
Front Floor Console Replacement.
Lift both cable adjustment retainers (1), one for
each cable, to release the shift lever and selector lever cable.
.1
Pull the shift lever and selector lever cable ret ...