Chevrolet Sonic Repair Manual: Generator Pulley Replacement (LUV)
|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the generator. Refer to Generator Replacement. |
|
|
1 |
Generator Pulley Nut Cap |
|
2 |
Generator Pulley Nut Caution: Refer to Fastener Caution. Procedure
Remove the generator pulley nut by using EN-6372 counterhold . Tighten
90 Y (66 lb ft) Special Tools
EN-6372 Counterhold For equivalent regional tools, refer to Special Tools. |
|
3 |
Generator Pulley |
|
4 |
Generator |
Power Steering Pump Belt Removal
Caution: Do not use belt dressing on the drive belt. Belt dressing
causes the breakdown of the composition of the drive belt. Failure to follow
this recommendation will damage the ...
Starting System
...
Other materials:
Input and Output Speed Sensor Removal
Input and Output Speed Sensor Removal
Callout
Component Name
1
A/Trans Output Speed Sensor Bolt M6 x 18 (Qty: 1)
2
A/Trans Output Speed Sensor Assembly
...
Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS). The TPMS is designed
to warn the driver when a low tire pressure condition exists. TPMS sensors are mounted
onto each tire and wheel assembly, excluding the spare tire and wheel assembly.
The TPMS sensors monitor the air pressure in ...
Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange,
remeasure the tire and wheel assembly on-vehicle runout in order to verify that
the amount of runout has been reduced and brought to within tolerances.
Mark the location of the high spot on the tire and wheel asse ...
0.006