Chevrolet Sonic Owner's Manual: Headlamp High/Low-Beam Changer
(Headlamp High/Low-Beam Changer):
Push the turn signal lever away from you to turn the high beams on.
Push the lever again or pull the lever toward you to return to low beams.
This indicator light turns on in the instrument cluster when the high-beam headlamps are on.
Exterior Lamp Controls
The exterior lamp control is on the instrument panel to the outboard side of
the steering column.
There are four positions:
(Off): Briefly turn to this position
to turn the automatic light co ...
Flash-to-Pass
To flash the high beams, pull the turn signal lever all the way toward you. Then
release it. ...
Other materials:
Exhaust Manifold Heat Shield Installation
Install the exhaust manifold heat shield (2).
Caution: Refer to Fastener Caution.
Install the 3 exhaust manifold heat shield bolts (1) and the washers and
tighten to 8 Y (71 lb in).
...
Knock Sensor System Description
Circuit/System Description
The knock sensor system enables the engine control module (ECM) to control
the ignition timing for the best possible performance while protecting the engine
from potentially damaging levels of detonation. The ECM uses the knock sensor
system to test for ...
Automatic Transmission Flex Plate Installation
Special Tools
EN-652 Automatic Transmission Flex Plate Holder
For equivalent regional tools, refer to Special Tools.
Clean the automatic transmission flex plate bolt threads.
Install the automatic transmission flex plate (2) and
the EN-652 holder to hold the automatic tran ...
0.0071