Chevrolet Sonic Repair Manual: Headlamps, Front Turn Signal and Parking Lamps
Passenger Side Shown, Driver Side Similar
- High-Beam Headlamp
- Low-Beam Headlamp
- Parking/Turn Signal Lamps
- High-Beam Headlamp/Low-Beam Headlamp
-
- Open the hood. See Hood.
- For the driver side bulb, remove the windshield washer bottle filler neck by turning it one-quarter turn counterclockwise and pulling it straight up and out of the bottle.
- Remove the headlamp bulb access cover.
- Turn the bulb counterclockwise and pull straight back.
- Disconnect the wiring harness connector from the bulb.
- Install the new bulb in the headlamp assembly by turning clockwise.
- Reconnect the wiring harness connector.
- Install the headlamp bulb access cover.
- For the driver side bulb, replace the windshield washer bottle filler neck by turning it one-quarter turn clockwise into the bottle.
- Parking/Turn Signal Lamp
-
- Open the hood. See Hood.
- Remove the parking/turn signal lamp bulb socket from the headlamp assembly by turning counterclockwise.
- Remove the bulb from the bulb socket by pulling it straight out.
- Install the new bulb in the bulb socket.
- Install the bulb socket into the headlamp assembly by turning clockwise.
Headlamp Bulb Replacement
Headlamp Bulb Replacement
Callout
Component Name
Preliminary Procedure
Open and support the hood assembly.
1
...
License Plate Lamp
Lamp Assembly
Bulb Assembly
Bulb Socket
Bulb
Lamp Assembly
To replace one of these bulbs:
Push the left end of the lamp assemb ...
Other materials:
Door Lock Switch Replacement
Door Lock Switch Replacement
Callout
Component Name
Preliminary Procedure
Remove the heater and air conditioning control. Refer to Heater and Air
Conditioning Control Replacement.
1
Door Lock Sw ...
Rail Dust Damage Repair
Warning: Refer to Eye Protection Warning.
Note: If rail dust has penetrated into the basecoat, the panel requires
refinishing. Ensure all the rail dust has been removed prior to refinishing
or the rust spots will return.
Rail dust damage comes from the tiny iron particles produce ...
Park - Engine Running (Gen 1)
When the gear selector lever is in the Park (P) position, fluid is drawn into
the pump through the transmission fluid filter assembly. Line pressure is then directed
to the following valves:
Fluid Pressure Directed in Preparation
for a Shift
Manual Valve
Mechanically controlled ...
0.0056