Chevrolet Sonic Repair Manual: Heated Oxygen Sensor Replacement - Sensor 1
|
Callout |
Component Name |
|---|---|
|
Warning: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool. Preliminary Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. |
|
|
1 |
Heated Oxygen Sensor 1 Caution: Refer to Component Fastener Tightening Caution.
42 Y(31 lb ft) Special Tools
EN-48259 Installer/Remover For equivalent regional tools, refer to Special Tools |
Knock Sensor System Description
Circuit/System Description
The knock sensor system enables the engine control module (ECM) to control
the ignition timing for the best possible performance while protecting the engine
...
Heated Oxygen Sensor Replacement - Sensor 2
Heated Oxygen Sensor Replacement - Sensor 2
Callout
Component Name
1
Heated Oxygen Sensor 2
Warning: In or ...
Other materials:
Fog Lamps (RS)
To replace the front fog lamp bulb:
Locate the fog lamp located under the front fascia.
Remove the cap from the back of the fog lamp assembly.
Disconnect the electrical connector from the fog lamp bulb assembly.
Remove the bulb by turning it counterclockwise and pulling it straight out ...
Headlamp Aiming
Visual Aiming Preparation Procedure
Note: Some state and local laws specify requirements for headlamp
aim. Comply with all of these laws when performing any headlamp aiming operations.
Headlamp aim should be checked:
When a new headlamp capsule is installed.
If ser ...
Hood Rear Seal Replacement
Hood Rear Seal Replacement
Callout
Component Name
1
Hood Rear Seal
Procedure
Clean the area where the seal will be mounted. Use a suitable solvent
with a mixture of 50?€‰percent isopropyl alcohol and 50?â ...
0.0076