Chevrolet Sonic Repair Manual: Heater Inlet Hose Replacement (LDE, LUW)
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, refer to Special Tools.
- Removal Procedure
-
- Drain the cooling system. Refer to Cooling System Draining and Filling.
- Disengage the heater inlet hose quick connect clip (1) at the heater core.
- Remove the heater inlet hose (2) from the heater core.
- Remove the heater inlet hose clamp (1) at the engine using BO-38185 Hose Clamp Pliers .
- Remove the heater inlet hose (2) from the engine.
- Remove the heater inlet hose from the vehicle.
- Installation Procedure
-
- Install the heater inlet hose to the vehicle.
- Install the heater inlet hose (2) to the engine.
- Install the heater inlet hose clamp (1) at the engine using BO-38185 Hose Clamp Pliers .
- Install the heater inlet hose (2) to the heater core.
- Engage the heater inlet hose quick connect clip (1) at the heater core.
- Fill the cooling system. Refer to Cooling System Draining and Filling.
Note:
The quick connector has an internal anti-rotation feature. The ensure the quick connector is properly aligned to the heater core pipe, position the white mark to the 12:00 O’clock position during installation.
Heater Core Replacement
Heater Core Replacement
Callout
Component Name
Preliminary Procedures
Remove the Heater and Air Conditioning Evaporator and Blower ...
Heater Inlet Hose Replacement (LUV)
Heater Inlet Hose Replacement
Callout
Component Name
Preliminary Procedures
Drain the engine coolant. Refer to Cooling System Drain ...
Other materials:
Safety Locks
The rear door safety locks prevent passengers from opening the rear doors from
inside the vehicle.
Manual Safety Locks
If equipped, the safety lock is located on the inside edge of the rear doors.
To use the safety lock:
1. Insert the key into the safety lock slot and turn it so the slot is ...
Transmission Replacement
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Disconnect the transmission range selector lever cable
terminal (1) from the transmission manual pin.
Press the locking tab forward in order to release
the tran ...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...
0.0046