Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Hood Adjustment



Hood Adjustment

Callout

Component Name

1

Hood

Caution:

Refer to Fastener Caution.

Procedure

  1. Loosen the 4 hood hinge nuts.
  2. Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the front bumper fascia and so that the hood is flush with both fenders on the front edge, the front bumper fascia and the headlamps.
Adjustment:

  • Hood to front fender?€‰(a) 3.0?€‰mm?€‰?±?€‰0.75?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.03?€‰in)
  • Hood to headlamp?€‰(b) 3.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.04?€‰in)
  • Hood to front bumper fascia?€‰(c) 3.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.04?€‰in)
Tighten


22?€‰Y (16?€‰lb?€‰ft)

Fuel Tank Filler Door Replacement
Fuel Tank Filler Door Replacement Callout Component Name 1 Fuel Tank Filler Door Procedure Position the fuel tank ...

Hood Ajar Indicator Description and Operation
Hood Ajar Switch The body control module (BCM) applies B+ to the hood ajar signal circuit and monitors the voltage to determine the position of the hood. When the hood is closed, the sw ...

Other materials:

Electrical System Overload
The vehicle has fuses and circuit breakers to protect against an electrical system overload. When the current electrical load is too heavy, the circuit breaker opens and closes, protecting the circuit until the current load returns to normal or the problem is fixed. This greatly reduces the c ...

Rear window defroster and outside mirror defroster
Example In the Nissan Armada, the rear window and outside mirror defroster switch is conveniently located on the front climate control panel for quick and easy access. To clear fog or frost from the rear window and outside mirrors in the Nissan Armada, start the engine and press the defros ...

Starting the engine
Basic information 1. Apply the parking brake. 2. Confirm that the Nissan Armada is in the P (Park) position. The Intelligent Key must be inside the Nissan Armada when operating the ignition system. 3. Press the ignition switch to the ON position. Then depress the brake pedal and press the ig ...

© 2014-2026 Copyright www.csmans.com
 
0.006