Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Hood Adjustment



Hood Adjustment

Callout

Component Name

1

Hood

Caution:

Refer to Fastener Caution.

Procedure

  1. Loosen the 4 hood hinge nuts.
  2. Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the front bumper fascia and so that the hood is flush with both fenders on the front edge, the front bumper fascia and the headlamps.
Adjustment:

  • Hood to front fender?€‰(a) 3.0?€‰mm?€‰?±?€‰0.75?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.03?€‰in)
  • Hood to headlamp?€‰(b) 3.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.04?€‰in)
  • Hood to front bumper fascia?€‰(c) 3.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.04?€‰in)
Tighten


22?€‰Y (16?€‰lb?€‰ft)

Hood Assembly
...

Hood Hold-Open Device Warning
Warning: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. ...

Other materials:

Front Fog Lamp Bulb Replacement
Front Fog Lamp Bulb Replacement Callout Component Name Preliminary Procedure Remove either the left front or right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. Disconnect the electrical connector t ...

Sunroof Motor/Actuator Initialization/Teach Process
Note: If the sunroof motor is new, cycle the sunroof seven?€‰(7) times to teach the motor/actuator initialization process. Perform the initialization/teach procedure on a reinstall motor or a new motor. Ensure the electrical harness on the headliner is connected to the sunroof mot ...

Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure Remove the front wheel drive shaft inner joint and boot. Refer to Front Wheel Drive Shaft Replacement. Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3). Remove the wheel drive shaft tripod housi ...

© 2014-2026 Copyright www.csmans.com
 
0.0081