Chevrolet Sonic Repair Manual: Hood Assembly
- Hood Adjustment
- Hood Hold-Open Device Warning
- Hood Hold-Open Rod Replacement
- Hood Primary Latch Release Cable Handle Replacement
- Hood Primary Latch Release Cable Replacement
- Hood Primary and Secondary Latch Replacement
- Hood Rear Seal Replacement
- Hood Rear Weatherstrip Replacement
- Hood Replacement
- Hood Side Seal Replacement
- Hood Hinge Replacement
- Hood Insulator Replacement
Seat Belt Latch Stop Installation
Seat Belt Latch Stop Installation
Callout
Component Name
Preliminary Procedure
Locate the hole in the seat belt webbing where the o ...
Hood Adjustment
Hood Adjustment
Callout
Component Name
1
Hood
Caution: Refer to Fastener Caution.
Procedure
Loosen t ...
Other materials:
Steering Linkage Outer Tie Rod Inspection
Special Tools
GE-8001 Dial Indicator Set
For equivalent regional tools, refer to Special Tools.
Note: This inspection procedure does not supersede local government
required inspections that have more stringent requirements.
Inspect the outer tie rod seal. If the outer tie rod ...
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Replacing Engine Gaskets
Gasket Reuse and Applying Sealants
Do not reuse any gasket unless specified.
Gaskets that can be reused will be identified in the service procedure.
Do not apply sealant to any gasket or sealing surface unless called
out in the service information.
Separating ...
0.007