|
Callout |
Component Name |
|---|---|
|
1 |
Hood Insulator Plastic Retainer (Qty:?€‰6) |
|
2 |
Hood Insulator Procedure
Ensure the 3 integral tabs are secured to the hood. |
Hood Hold-Open Rod Replacement
Hood Primary Latch Release Cable Handle ReplacementPower Steering Control Module Programming and Setup
The following service procedures require either a programming or a setup event
performed for a complete repair.
Power Steering Control Module Replacement
If the steering column power steering control module needs to be is replaced,
the power steering control module needs to be progra ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...
Oil Level Indicator and Tube Removal
Remove the oil dipstick.
Remove the oil level indicator tube bolt (1).
Note: If the engine oil level is at the maximum level, oil may
emerge while removing the oil dipstick guide tube.
Remove the oil level indicator tube (2) and oil level indicator seal.
...