|
Callout |
Component Name |
|---|---|
|
1 |
Hood Insulator Plastic Retainer (Qty:?€‰6) |
|
2 |
Hood Insulator Procedure
Ensure the 3 integral tabs are secured to the hood. |
Hood Hinge ReplacementSteering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Evaporative Emission Canister Replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the EVAP canister cover fasteners (1) and cover (2).
Warning: Do not breathe the air through the EVAP component
tubes or hoses. The fuel vapors inside t ...
Ignition and Start Switch Replacement
Ignition and Start Switch Replacement
Callout
Component Name
Preliminary Procedures
Disconnect the battery negative cable. Refer to Battery Negative
Cable Disconnection and Connection.
Remove the ignition and start switch ...