
|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Hood Primary Latch Cable Procedure
Disconnect the hood primary latch release cable from the primary hood latch. |
|
2 |
Hood Primary Latch Release Cable Retainer Procedure
Disconnect the hood release cable retainers from the hood release cable. |
|
3 |
Hood Primary Latch Release Cable Grommet |
|
4 |
Hood Primary Latch Release Cable Procedure
Disconnect the hood primary latch release cable handle from the hood latch cable. Refer to Hood Primary Latch Release Cable Handle Replacement. |
Hood Primary Latch Release Cable Handle ReplacementDoor Lock and Ignition Lock Folding Key Blade Removal and Installation
Special Tools
BO-51098 Flip Key Blade Fixture
For equivalent region tools, refer to Special Tools.
Caution: Failure to properly support the Remote Keyless Entry
(RKE) transmitter assembly while replacing the key blade may cause internal
damage to the transmitter assembly. ...
Tire and Wheel Balancing (Wheel Pilot Bore Greasing)
Beginning with MY 2011 vehicle, pilot bore grease should be applied.
To enable this, grease must be applied to the pilot bore to prevent the
wheel from seizing onto the hub.
Refer to Adhesives, Fluids, Lubricants, and Sealers for pilot bore lubricant
part number.
Do not use any pene ...
Engine Front Cover and Oil Pump Assemble
Oil Pump Installation
Note: The oil pump slide spring and pin, as well as the slide
seal and slide seal spring can be ordered as single parts. All other
oil pump components can only be ordered as a replacement kit.
Install the oil pump components in the fo ...