
|
Callout |
Component Name |
|---|---|
|
1 |
Hood Rear Weatherstrip Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers that are part of the air inlet grille. Carefully pull the weatherstrip to the right/left to release from the retainers on the air inlet grille. |
Front Side Door Window Weatherstrip Replacement
Liftgate Weatherstrip ReplacementOnStar Description and Operation
This OnStar® system consists of the following components:
Telematics communication interface control module
OnStar® three button assembly
Microphone
Cellular antenna
Navigation antenna
Bluetooth® antenna (If equipped)
Back up battery (If equipped)
This system also interfaces wi ...
Inflatable Restraint Remote Impact Sensor Replacement
Inflatable Restraint Remote Impact Sensor Replacement
Callout
Component Name
Warning: When performing service on or near the SIR components
or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling
a ...
Brake Rotor Thickness Measurement
Warning: Refer to Brake Dust Warning.
If the inboard friction surface of the brake rotor is not accessible, reposition
and support the caliper with the brake pads. Refer to Front Disc Brake Pads
Replacement.
Clean the friction surfaces of the brake rotor with denatured al ...