
|
Callout |
Component Name |
|---|---|
|
1 |
Hood Rear Weatherstrip Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers that are part of the air inlet grille. Carefully pull the weatherstrip to the right/left to release from the retainers on the air inlet grille. |
Hood Rear Seal Replacement
Hood ReplacementCharging System Light
This light will come on briefly when the ignition is turned on, and the engine
is not running, as a check to show it is working.
It should go out when the engine is started. If it stays on, or comes on while
driving, there may be a problem with the electrical charging system. Have it checked ...
Aluminum Wheel Porosity Repair
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
Inflate the tire to the manufacturer specified pressure as stated on the
tire.
Submerge the tire/wheel into a water bath in order t ...
Timing Belt Replacement
Special Tools
EN-6333 Timing Belt Tensioner Locking Pin
EN-6340 Camshaft Locking Tool
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Note: If the timing belt is being replaced due to the maintenance
schedule interval, then the timing belt t ...