|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Disconnect the windshield washer nozzle hose. |
|
|
1 |
Hood Hinge Nut (Qty:?€‰4) Caution: Refer to Fastener Caution. Procedure
Mark the location of the hinge to the hood with a grease pencil to aid in alignment. Tighten
22?€‰Y (16?€‰lb?€‰ft) |
|
2 |
Hood Procedure
|
Hood Rear Weatherstrip Replacement
Hood Side Seal ReplacementRear Side Door Window Rear Guide Replacement
Rear Side Door Window Rear Guide Replacement
Callout
Component Name
Preliminary Procedure
Remove the rear side door trim panel. Refer to Rear Side Door Trim Replacement.
1
Rear Side Door Window R ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the
cylinder head.
Disconnect the ignition coil electrical connector (2).
...
3-5-Reverse and 4-5-6 Clutch Housing Disassemble (6T30/40/45/50 - Gen 2)
Table 1:
Turbine Shaft, Reluctor Wheel and Piston Removal
Table 2:
4?? Clutch Plate Removal
Table 3:
4?? Clutch Piston Removal
Table 4:
Reluctor Wheel and Piston Removal
Table 5:
3? Reverse Clutch Plate Removal
Turbine Shaft, Re ...