Callout |
Component Name |
---|---|
Preliminary Procedure
Disconnect the windshield washer nozzle hose. |
|
1 |
Hood Hinge Nut (Qty:?€‰4) Caution: Refer to Fastener Caution. Procedure
Mark the location of the hinge to the hood with a grease pencil to aid in alignment. Tighten
22?€‰Y (16?€‰lb?€‰ft) |
2 |
Hood Procedure
|
Trunk (Sedan)
Warning
Exhaust gases can enter the vehicle if it is driven with the liftgate, hatch/trunk
open, or with any objects that pass through the seal between the body and the hatch/trunk
or liftgate. Engine exhaust contains carbon monoxide (CO) which cannot be seen or
smelled. It can cause unconsci ...
Tire and Wheel Assembly Balancing - On-Vehicle
Special Tools
EL-38792-A Electronic Vibration Analyzer (EVA) 2
If after following the tire and wheel vibration diagnostic process, some amount
of tire and wheel vibration is still evident, an on-vehicle high-speed spin balancer
may be used to perform an on-vehicle balance in an attempt ...
Clutch and Differential Housing Assemble
Special Tools
R-0007761 Universal Handle for Pullers and Installers
R-0407009 Countershaft Front Bearing Driver
R-0407010 Input Shaft Needle Bearing Puller and Driver
R-0407014 Gearshift Device Bushing Driver ?#8201;Use with R-0007761
S-9707500 Axle Shaft Seal Installer
For ...