|
Callout |
Component Name |
|---|---|
|
1 |
Hood Side Seal Push-In Retainer (Qty:?€‰6) |
|
2 |
Hood Side Seal |
Hood Replacement
Liftgate AdjustmentLiftgate Weatherstrip Replacement
Liftgate Weatherstrip Replacement
Callout
Component Name
1
Liftgate Weatherstrip
Procedure
Clean the area where the seal will be mounted. Use a suitable solvent
with a mixture of 50?€‰percent isopropyl alc ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Engine Oil Cooler Housing Installation
Clean the engine oil cooler housing to thermostat housing sealing surfaces.
Install 2 NEW gaskets.
h.\.\,.\\..,v:..//
Install the engine oil cooler inlet pipe (3).
Install the engine oil cooler housing (1) and the 5 engine oil cooler bolts (2)
and t ...