Chevrolet Sonic Repair Manual: Hydraulic Valve Lash Adjuster Arm Installation
- Lubricate the hydraulic valve lash adjuster arms with engine oil.
- Install the 16 hydraulic valve lash adjuster arms (1).
Note:
Hydraulic valve lash adjuster arms should be installed in their original position.
Valve Stem Oil Seal and Valve Spring Replacement
Special Tools
207649 Rod Hairpin Clips
547324 Flange Screws
EN-840 Pliers / Remover
EN-958 Installer
EN-45059 Angle Meter
EN-50717 Kit
J-43649?E Rods
For equivalent regional to ...
Hydraulic Valve Lash Adjuster Arm Removal
Note: Mind the installation position of the hydraulic valve lash adjuster
arms.
Remove the 16 hydraulic valve lash adjuster arms (1). ...
Other materials:
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Engine Oil Cooler Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Drain engine coolant. Refer to Cooling System Draining and Filling
Remove the turbocharger oil feed pipe. Refer to Turbocharger Oil Feed
Pipe Replacement ...
Control Valve Body Assembly Installation
Control Valve Body Assembly Installation
Callout
Component Name
1
Low and Reverse Clutch Fluid Passage Seal
2
1-2-3-4 Clutch Fluid Passage Seal
3
Control Valve Body ...
0.0061