Chevrolet Sonic Repair Manual: Ignition and Start Switch Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / Ignition System / Ignition and Start Switch Replacement

Ignition and Start Switch Replacement
Callout	Component Name
Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the ignition and start switch housing. Refer to Ignition and Start Switch Housing Replacement.
1	Ignition and Start Switch Bolt (Qty: 2) Caution: Refer to Fastener Caution.
2	Ignition and Start Switch

Ignition and Start Switch Housing Replacement

Ignition and Start Switch Housing Replacement Callout Component Name Preliminary Procedures Remove the theft deterrent module. Refe ...

Lock Cylinder Coding - Ignition

The ignition lock cylinder uses 8 key cut positions, 1?E. The ignition cylinder tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in and are ...

Other materials:

When the System Does Not Seem To Work Properly
If the LDW symbol does not appear: The lane markings on the road may not be seen. The camera sensor may be blocked by dirt, snow or ice. The windshield may be damaged. The weather may be limiting visibility. This is normal operation; the vehicle does not need service. Clean the windshie ...

Brake Fluid Level Indicator Switch Replacement
Removal Procedure Disconnect the brake fluid level indicator switch electrical connector. Using a small, flat-bladed tool, lift the locking tab on the underside of the brake fluid level indicator switch (1) and remove the switch. Inspect the maste ...

Water Pump Pulley Removal
Loosen the 3 water pump pulley bolts (2) while holding up the water pump pulley hub with a wrench. Remove the 3 water pump pulley bolts (2). Remove the water pump pulley (1). ...

0.0067