Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Ignition Coil Replacement

Chevrolet Sonic Repair Manual / Powertrain / Engine / Ignition System / Ignition Coil Replacement

Special Tools

EN-6009 Remover and Installer Ignition Coil

For equivalent regional tools, refer to Special Tools.

Removal Procedure

    Remove the engine wiring harness guide (1) from the cylinder head.
  1. Remove the engine wiring harness guide (1) from the cylinder head.
  2. Disconnect the ignition coil electrical connector (2).

    3. Note:

    Note the arrow on the cover.

  3. Remove the cover of the ignition coil in the direction of the arrow.
  4. Remove the ignition coil bolts.

  5. Install the EN-6009 remover/installer (1).
  6. Remove the ignition coil (2).
  7. Remove the EN-6009 remover/installer (1).
Installation Procedure

    Install the EN-6009 remover/installer (1).
  1. Install the EN-6009 remover/installer (1).
  2. Install the ignition coil (2).
  3. Remove the EN-6009 remover/installer (1).
  4. Install the ignition coil fasteners and tighten to 8 Y (71 lb in)

    .

    5. Note:

    Note the arrow on the cover.

  5. Install the ignition coil cover in the opposite direction of the arrow.

  6. Connect the ignition coil electrical connector (2).
  7. Install the engine wiring harness guide (1) at the cylinder head.
Ignition Coil Removal
Special Tools EN-6009 Remover and Installer Ignition Module For equivalent regional tools, refer to Special Tools. Remove the 2 ignition coil bolts (1). Install EN- ...

Spark Plug Inspection
Spark Plug Usage Ensure that the correct spark plug is installed. An incorrect spark plug causes driveability conditions. Ensure that the spark plug has the correct heat range. An ...

Other materials:

Front Floor Console Cover Replacement (Manual Transmission)
Removal Procedure Use a flat bladed plastic trim tool in order to release the retainers securing the console cover?€‰(1) to the console assembly. Reach under the console cover assembly?€‰(1) and release the retainer tabs securing the transmission shif ...

Crankshaft and Bearing Removal
Identify all the connecting rod bearing caps (1). Remove the 4 bolts. Remove the connecting rod bearing caps 1 and 4 (1). Turn the crankshaft through 180°. Remove the 4 bolts. Remove the connecting rod bearing caps 2 and 3 ( ...

Control Valve Body Assembly Installation
Control Valve Body Assembly Installation Callout Component Name 1 Low and Reverse Clutch Fluid Passage Seal 2 1-2-3-4 Clutch Fluid Passage Seal 3 Control Valve Body ...

© 2014-2026 Copyright www.csmans.com
 
0.005