Chevrolet Sonic Repair Manual: Ignition Lock Cylinder Replacement
- Removal Procedure
-
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove the upper trim cover and the lower trim cover from the steering column. Refer to Steering Column Lower Trim Cover Replacement.
- Insert the key into the ignition lock cylinder and turn the key to the RUN position.
- Push a pick-type tool into the access hole (2) in the ignition and start switch housing and press the ignition lock cylinder lock tab down.
- Remove the ignition lock cylinder (1) from the ignition and start switch housing.
- Installation Procedure
-
- If you are installing a new ignition lock cylinder, code the lock cylinder. Refer to Lock Cylinder Coding - Ignition.
- Turn the key to the RUN position and insert ignition lock cylinder (1) into the ignition and start switch housing.
- Turn the key to the LOCK position and remove the key from the ignition lock cylinder.
- Install the upper trim cover and the lower trim cover to the steering column. Refer to Steering Column Lower Trim Cover Replacement.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
Door Lock and Ignition Lock Folding and Non-Folding Key Cutting
High Security keys are available from the service parts system.
Obtain the key code from the security card or from the GM Dealer World, Parts,
Key Code Look Up system.
If you have the key code a ...
Immobilizer
...
Other materials:
Outside Mirror Description and Operation
Power Mirror System Components
The power mirror system consists of the following components:
Outside rearview mirror switch
Mirror selector switch
Driver outside rearview mirror
Passenger outside rearview mirror
Each of the outside rearview mirror contains two motors. Th ...
Differential Carrier Removal (6T30)
Differential Carrier Removal
Callout
Component Name
1
Differential Carrier Assembly
2
Final Drive Sun Gear
...
Automatic Transmission Flex Plate Removal
Special Tools
EN-652 Automatic Transmission Flex Plate Holder
For equivalent regional tools, refer to Special Tools.
Install the EN-652 holder (1) to hold the automatic
transmission flex plate (2).
Loosen the 6 automatic transmission flex plate bolts.
Re ...
0.0052