While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
On all vehicles, the ignition key should come out only in LOCK/OFF.
Contact your dealer if service is required.
Transmission Adaptive FunctionsInstrument Panel Tie Bar Replacement
Removal Procedure
Remove the Instrument panel assembly. Refer to Instrument Panel Assembly
Replacement.
Remove the steering column and wheel from the vehicle. Refer to Steering
Column Replacement.
Remove the air inlet grill panel. Refer to Air Inlet Grille Panel Replacem ...
Scrub Radius Description
Ideally, the scrub radius is as small as possible. Normally, the SAI angle and
the centerline of the tire and the wheel intersect below the road surface, causing
a positive scrub radius. With struts, the SAI angle is much larger than the long
arm/short arm type of suspension. This allows the S ...
Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral
(N) position, the transmission will provide engine braking. In this operating range,
the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine
braking mode, the following changes occur with ...