Chevrolet Sonic Repair Manual: Indicator/Warning Message Description and Operation
- Indicator LIGHT ON
-
Refer to the owner's manual for the descriptions and explanations of all indicator lights.
For diagnosis and repair information related to an indicator light, refer to the System Diagnosis and the Description of Operation that the message relates to.
- Message Displayed
-
Refer to the owner's manual for descriptions and explanations of all messages displayed.
For diagnosis and repair information related to a displayed message, refer to the System Diagnosis and the Description of Operation that the message relates to.
- CHANGE TIMING BELT MESSAGE
-
The Instrument Cluster monitors the odometer mileage to determine when timing belt (if equipped) replacement may be necessary. After the vehicle has accumulated approximately 100,000 miles (160,000 kilometers), the Instrument Cluster may display the CHANGE TIMING BELT message. After the engine timing belt has been replaced, reset the CHANGE TIMING BELT message by locating and removing the fuses that supply power to the Instrument Cluster for two minutes.
Hood Ajar Indicator Description and Operation
Hood Ajar Switch
The body control module (BCM) applies B+ to the hood ajar signal circuit
and monitors the voltage to determine the position of the hood. When the hood
is closed, the sw ...
Parking Brake Indicator Switch Replacement
Removal Procedure
Remove the front floor console. Refer to
Front Floor Console Replacement.
Ensure that the park brake lever is in the fully released
position.
Disconnect t ...
Other materials:
Additional Maintenance and Care
Your vehicle is an important investment and caring for it properly may help to
avoid future costly repairs. To maintain vehicle performance, additional maintenance
services may be required.
It is recommended that your dealer perform these services — their trained dealer
technicians know you ...
Front Wheel Bearing and Hub Replacement
Special Tools
CH-50559 Wheel Hub/Bearing Remover Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the steering knuckle assembly from the vehicle. Refer to Steering
...
Transmission Case Disassemble (Gen 1)
Special Tools
3-9506289 Universal Adapter
J-810700 Mainshaft Bearing Remover
J-810704 Center Bar Puller
M-680770 Universal Sliding Mallet
R-0007758 Holding Fixture
R-0007770 Holding Fixture Adapter Plates
T-0307000 Extractor and Driver Fixture
T-9807671 Slide Hammer
For eq ...
0.0049