Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Inflatable Restraint Remote Impact Sensor Replacement

Chevrolet Sonic Repair Manual / Body / Restraints / Restraints Control / Inflatable Restraint Remote Impact Sensor Replacement



Inflatable Restraint Remote Impact Sensor Replacement

Callout

Component Name

Warning:

When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

Warning:

Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling.
  2. Remove front side door trim panel. Refer to Front Side Door Trim Replacement.

1

Inflatable Restraint Remote Impact Sensor Assembly

Caution:

Refer to Fastener Caution.

Procedure

  1. Loosen the fastener and slide the sensor out of key hole slot.
  2. The bolt is integral to the sensor assembly, DO NOT remove separately.
  3. Disconnect the electrical connector.
Tighten


7.5?€‰Y?€‰(66?€‰lb?€‰in)

Airbag Side Impact Sensor Replacement (with AYF/AYO)
Airbag Side Impact Sensor Replacement Callout Component Name Warning: Refer to SIR Warning. Warning: Refer to SIR ...

Multi-Axis Acceleration Sensor Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia Sensor Module (IMU) is not pro ...

Other materials:

Radio Antenna Replacement
Radio Antenna Replacement Callout Component Name 1 Radio Antenna Procedure Rotate the mast counterclockwise in order to release the mast from the antenna base. ...

Power Door Locks Description and Operation
Door Lock System Components The power door lock system consists of the following components: Driver door lock switch Child door lockout switch Door lock actuators in each of the doors Body control module (BCM) Underhood fuse block (Contains door lock PCB relay) ...

Drive Range, Fifth Gear Default (Gen 1)
If the transmission encounters an electrical component malfunction, the transmission will default to Fifth gear. All solenoids will default to their normal state. If the torque converter clutch is applied, it will release. The transmission will remain in Drive Range?Fifth Gear Default until th ...

© 2014-2026 Copyright www.csmans.com
 
0.0255