|
Callout |
Component Name |
|---|---|
|
1 |
Input Speed Sensor Assembly Seals |
|
2 |
Input Speed Sensor Assembly |
|
3 |
Input Speed Sensor Bolt M6 x 23 (Qty: 1) Caution: Refer to Fastener Caution.
9 Y (80 lb in) |
|
4 |
A/Trans Output Speed Sensor Assembly |
|
5 |
A/Trans Output Speed Sensor Bolt M6 x 18 (Qty: 1) Tighten
9 Y (80 lb in) |
Input Speed Sensor Replacement
Input and Output Speed Sensor RemovalBattery Description and Operation
Warning: Batteries produce explosive gases, contain corrosive acid,
and supply levels of electrical current high enough to cause burns. Therefore,
to reduce the risk of personal injury when working near a battery:
Always shield your eyes and avoid leaning over the battery whenever
...
Exhaust Manifold Installation
Clean the exhaust manifold sealing surface.
Install a NEW exhaust manifold gasket (1) to the cylinder head.
Caution: Refer to Fastener Caution.
Caution: Refer to Torque-to-Yield Fastener Caution.
Install the exhaust manifold (3) and tighten the NEW nu ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the
cylinder head.
Disconnect the ignition coil electrical connector (2).
...