Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Input Shaft Support Replacement (Gen 1)

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Input Shaft Support Replacement (Gen 1)



Input Shaft Support Replacement

Callout

Component Name

1

3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 4)

Note:

  • Discard the fluid seals. They are not reusable.
  • Refer to 3-5-Reverse and 4-5-6 Clutch Fluid Seal Ring Replacement.

2

Input Shaft Support Bolts M6 x 50 (Qty: 3)

Caution:

Refer to Fastener Caution.

Tighten


12 Y (106 lb in)

3

Input Shaft Support

Note:

Inspect the support for wear, damage or porosity.

Front Wheel Drive Shaft Seal Replacement - Right Side
Front Wheel Drive Shaft Seal Replacement - Right Side Callout Component Name Preliminary Procedures Raise and support the vehicle. ...

Input Shaft Support Replacement (Gen 2)
Input Shaft Support Replacement Callout Component Name 1 3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 3) ...

Other materials:

Hood Primary and Secondary Latch Replacement
Hood Primary and Secondary Latch Replacement Callout Component Name 1 Hood Primary and Secondary Latch Bolt (Qty:?€‰2) Caution: Refer to Fastener Caution. Tighten 22?€‰Y (16?€‰lb?€‰ft) ...

Fuel Pump Control Module Programming and Setup
The fuel pump control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the fuel pump control module will not control all of the vehicle features proper ...

Engine Flywheel Removal
Special Tools EN-652 Flywheel Holder For equivalent regional tools, refer to Special Tools. Install EN-652 holder  (1) to hold the engine flywheel (2). Remove and DISCARD the 6 engine flywheel bolts (2). Remove the engine flywheel (1). ...

© 2014-2026 Copyright www.csmans.com
 
0.007